Little Buddy Fiberglass Fish Tape Wire Puller, 3/16 x 300', Jameson Tools

September 25,2024

Little Buddy® Fiberglass Fish Tape Wire Puller, 3/16 in. x 300 ft. Jameson Little Buddy fiberglass fish tape is a lightweight and portable unit that is ideal for running inside and outside conduit drops. The non-conductive wire puller features a round rod that slides easily over existing wires through multiple bends. Operates vertically or horizontally with a drag brake and safety feed eye to control payout. The included accessory kit stores in a canvas pouch for convenient access.

Little Buddy 300 ft. x 3/16 in. Fiberglass Conduit Rodder - tools

7/16 inch Python Rod - 1500' - Comstar Supply - Netceed

Buddy Duct Conduit Rodders and Fish Tapes are the most durable on the market, however job sites can be extremely rough. On occasion it may be necessary to replace the entire coil of duct rod due to more severe damage. Removal, disposal and rod replacement can be difficult and time-consuming.

Jameson 6-500RRM Easy Buddy Conduit Rodder EZ-Reel, 1/4in x 500ft, Marked Every 5ft

The Jameson Wee Buddy Fish Tape with 100 Ft. of 1/8 in. Fiberglass Rod is ideal for pulling phone wire, network cable or speaker wire through walls and occupied electrical conduit. Due to the round rod design, this non-conductive fish tape slides easily over existing wires, especially at bends, with a smooth, non-binding payout and return.

Jameson 8-18-100K Fish Tape, 1/8 in x 100 ft, Fiberglass

Jameson 11A-25-500M 500' x 3/8 Good Buddy II Conduit Rodder

Fish Tapes Power & Tel

Little Buddy® Fiberglass Fish Tape Wire Puller, 3/16 in. x 300 ft. Jameson Little Buddy fiberglass fish tape is a lightweight and portable unit that

10-316-300

Jameson 400' X 5/16 Duct Hunter, Marked Rod The Duct Hunter is a traceable duct rodder that offers a non-invasive solution for locating and mapping underground ducts and pipes. Save time by eliminating digging and trenching. The detectable fiberglass rod incorporates a copper trace wire that can be located at depths up to 10 feet. When used with a signal transmitter to energize the wire, an electromagnetic signal is then detected via hand-held receiver to trace the entire line.