Aluminum Laminated Film for Pouch Cell Case

September 23,2024

Aluminum Laminated Film for Pouch Cell Case is used as casing material for polymer Li-Ion battery. We supply Aluminum Laminated Film for Pouch Cell Case with high quality and low prices..
1 Roll/357 €3 Rolls/808 €5 Rolls/1095 € Please contact us for quotes on larger quantities !!! Aluminum Laminated Film for Pouch Cell Case Thickness: 113 μm, Width: 400 mm, Length: 10 m. Technical Properties: Layers from outside (Shiny) to inside (Mat) Polyamide (JIS Z1714): 0.025mm (+-0.0025mm) Adhesive (Polyester-polyurethane): 4-5 g/m2 Aluminum foil (JIS A8079,A8021): 0.040mm (+-0.004mm) Adhesive (Urethane-free Adhesive): 2-3 g/m2Polypropylene: 0.040mm (+-0.004mm) Thickness 113 μm Width 400 mm Length 10 m Surface quality Mat finish Pinholes Subject to the applicable aluminum foil standard Impurity 1 mm or less in diameter Fish Eye 2 mm or less in diameter (clear),1 mm or less in diameter (colored) Molding Depth ≥5.0 mm Electrical Insulating Good Hot Sealing Conditon 180-190°C Moisture Vapor / O2 Transmission Rate 200 ppm / 5 years Laminate Strength Nylon/Al more than 2N/15mm Al/CPP more than 5N/15mm Heat Seal Strength More than 22.5N/15mm wide at 200℃ x 0.2Mpa x2 sec by TOB heat sealing Solvent Retention Less than 5mg/m2 Appearance Within the sample of the limit Slip Factor CPP/CPP less than 1.0 Applications: Aluminum Laminated Film for Pouch Cell Case is used as casing material for polymer Li-Ion battery.