Simpson THA418 4x18 Adjustable Truss Hanger - G90 Galvanized

September 16,2024

Simpson Strong-Tie THA adjustable truss hangers' extra long straps allow full code nailing and can be field-formed to give top flange hanger convenience. Straps must be bent for top flange hanger installation. PAN nailing helps eliminate splitting of 4x2 truss bottom chords. The Strong-Tie THA418 adjustable truss hange.

Installation:

Use all specified fasteners.
For the THA29, nails used for joist attachment must be driven at an angle so that they penetrate through the corner of the joist and into the header. For all other top flange installations, straighten the double shear nailing tabs and install the nails straight into the joist.
Top Flange Installation—The straps must be field formed over the header - see table for minimum top flange requirements. Install top and face nails according to the table. Top nails shall not be within 1/4 from the edge of the top flange members.
Face Mount Installation—Install all face nails according to the table. Not all nail holes will be filled on all models. On models where there are more nail holes than required, the lowest 4 face holes must be filled. Nails used for the joist attachment must be driven at an angle so that they penetrate through the corner of the joist into the header.
Alternate Installation—The THA 4x hangers may be installed in a top flange configuration using the tabulated fasteners for face mount installation and achieve the face mount installation loads. Install the tabulated face nails into the face and top of the carrying member. Nails used for the joist attachment must be driven at an angle so that they penetrate through the corner of the joist into the header.
Uplift—Lowest face nails must be filled to achieve uplift loads.

NOTE: The correct fasteners installed in the correct position must be used to achieve published load values

California Residents: WARNING

Simpson Strong-Tie - Hanger - Truss Hangers - Tropical Construction Supply

Simpson THA218 2x18 Adjustable Truss Hanger - G90 Galvanized – Fasteners Plus

Simpson Strong-Tie HUC212-3TF - Galvanized Top-Flange Concealed-Flange Joist Hanger for Triple 2x12Product DetailsThe HUCTF is a hybrid hanger that incorporates the advantages of both face-mount and top-mount hangers. This heavy-duty joist hanger is designed with two concealed flanges for end-of-wall or corner installation. The HUCTF features face-nailing that allows the hanger to be securely attached to the member.

Simpson Strong-Tie HUC212-3TF Concealed Top Flange Hanger

Simpson Strong-Tie THA418 Adjustable Truss Hanger

Simpson Strong-Tie - Hanger - Truss Hangers - Tropical Construction Supply

Simpson Strong-Tie THASR29-2 - Double 2x9 Adjustable Truss Hanger, Skewed Right - G90 Galvanized The THASR/L is designed to support trusses and beams. This versatile U-shaped hanger combines the height adjustability of the THA with field adjustability. These key features provide maximum flexibility for the installer.

Simpson Strong Tie THASR29-2 Adjustable Truss Hanger

Simpson HU212-3TF Triple 2x12 Top Flange Face Mount Hanger - G90 Galva – Fasteners Plus

Simpson DSC2R-SDS3 16 Drag Strut Connector w/SDS Screws - Right Side, – Fasteners Plus

16 - Simpson Strong-Tie - Joist Hangers - Building Hardware - The Home Depot

This hanger features patented double shear nailing which distributes the load through two points on each joist nail for greater strength. 18 gauge. Minimum heel.

Simpson Strong-Tie LUS24 Joist Hanger